Replaced the kinked scratched aluminum gunwales on your Kevlar/composite canoe with this 1 part Profile.  It's the same gunwale system you see on new Wenonah canoes but can be used to refurbish your Souris River, Bell, Sawyer, and many others.... these gunwales will work for any composite hull up to 1/8th inch thick.

Gunwale length can be a few inches shorter on each end of the canoe.  The gap left by the short gunwale is then covered up by ABS end caps.  So if your boat is 17' long, you should be able to get by with at least a 16'6" long gunwale as long as your end caps are at least 3.75" long.  If the gunwale is longer than your canoe, it can be trimmed to fit.

Installation requires a hand drill and rivet gun, clamps and patience will come in handy too.

Sold as one side (1 piece).

Rivets, end caps and cross members sold separately